Toothed belt, tensioning

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, and 2004 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Tensioning Bolt T10092 And Locking Pin T40011 Installed

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Tension toothed belt. To do this, remove pin T40011 and remove tensioning bolt T10092.
Turn over crankshaft twice and check if markings on camshaft and crankshaft still align with their reference points.
Install vibration damper and belt pulley tightening torque: 25 Nm
Install center part of toothed belt (insert bolts with Locking Compound D 000 600 A2.) (Part numbers are for reference only. Always check with your Parts Department for the latest part number information). Torque specification: 10 Nm

Install toothed belt cover - upper part.
Install engine mount. Torque specifications:, refer to Assembly mounting .
Install tensioner for ribbed belt. Torque specification: 25 Nm
Install ribbed belt, refer to Ribbed belt, removing and installing .