Cylinder head, assembly overview: Notes
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, and 2004 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
1 - Cap
2 - 10 Nm
3 - Cylinder head cover
4 - Gasket for cylinder head cover
- Replace if damaged
- Before installing, coat contact surfaces of bearing cap or camshaft adjuster/chain tensioner to cylinder head with Sealant AMV 174 004 01 Double bearing cap contact surfaces, sealing and Chain tensioner or camshaft adjuster/cylinder head contact surfaces, sealing (Part numbers are for reference only. Always check with your Parts Department for the latest part number information).
5 - Oil deflector
- Note installation position: Above intake camshaft
6 - Cylinder head
- Check for distortion Checking cylinder head for distortion under Cylinder head, assembly overview
- Resurfacing sealing surfaces Refacing cylinder head sealing surface under Valvetrain, assembly overview
- Removing and installing, refer to Cylinder head, removing and installing
- After replacing replace entire amount of coolant
7 - Intake manifold gasket
- Replace
- Note installation position
8 - Cylinder head gasket
- Replace
- Metal gasket
- After replacing replace entire amount of coolant
- Note installation position: Identification: Part number must be visible from intake side
9 - Toothed belt
- Mark direction of rotation before removing
- Check for wear
- Do not kink
- Removing and installing, tensioning, refer to Toothed belt, removing, installing and tensioning
10 - Gasket for exhaust manifold
- Replace
- Note installation position
11 - Cylinder head bolt
- Replace
- Removing and installing polydrive cylinder head bolt using polydrive key 3452 or socket T10070
- Sequence for loosening and tightening, refer to Cylinder head, removing and installing
12 - Gasket
- Replace if damaged