Assembly overview
NOTE:
The following list refers to Fig 1.
- - Rocker panel trim
- - Self-tapping combi screw
- Qty: 7
- - Front cover strip
- - Pop rivet
- Qty: -2- for rocker panel trim
- Qty: -4- for wheel arch trim
- Qty: -3- for rear wheel arch trim
- - Spreader nut
- Qty. 7
- - Wheel arch trim
- - Clip
- - Sealing grommet
- - Retainer strip
- Removing and installing, refer to PROTECTIVE SIDE MOLDINGS, REPLACING .
- Self-adhesive
Installing:
- Clean exterior panels and afterwards treat with silicone remover and then rub dry.
- Pull off protective foil, attach retainer strip lightly and then press forcefully on. Working temperature approx. 20 °C (68 °F).
- - Cover strip