Alarm system control module -J284-, removing and installing: Removing

Remove driver's side instrument panel trim.
Refer to INSTRUMENT TRIM, REMOVING .
Disconnect 6-pin and 10-pin connectors from alarm system control module -J284-, located behind bracket on left A -pillar.
Vehicles with cruise control:
Disconnect 12-pin connector from cruise control, control module -J213-, located behind bracket on left A -pillar.

NOTE: The alarm system control module -J284- and cruise control, control module -J213- are located on the same mounting plate.

Remove nut -1- from assembly carrier.

Fig 1: Removing & Installing Alarm System Control Module -J284-
Courtesy of VOLKSWAGEN OF AMERICA, INC.
Pull mounting plate locking lugs out from bracket and remove mounting plate with control module -2-.
Remove control module mounting bolts from mounting plate and remove control module.
Install in reverse order of removal.