Engine, removing and installing: Removing

WARNING: This page is about a different car, the 1999 Volkswagen Jetta, 1998 Volkswagen Jetta, 1997 Volkswagen Jetta, 1996 Volkswagen Passat, and 1996 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Switch ignition off.
Disconnect battery Ground (GND) strap.

NOTE:

Remove engine and transmission (as an assembly) in a forward direction.
When re-installing the engine, replace or re - install all cable ties (in original position) which were loosened or cut during engine removal.

Remove air cleaner housing complete with intake hoses.
Loosen power steering reservoir hose clamp.
Disconnect power steering hydraulic lines from engine carrier and transmission.
Disconnect power steering pump with bracket and move to one side.

See POWER STEERING PUMP, SERVICING (VEHICLES WITH 1.8, 1.9, AND 2.0 LITER ENGINES) .

CAUTION: DO NOT disconnect power steering hoses.

See POWER STEERING PUMP, RESERVOIR AND HYDRAULIC LINES, SERVICING .

Drain engine coolant, see COOLING SYSTEM, DRAINING AND FILLING .