LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 1991 >> Vanagon Syncro >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Adjustments >> Brake Pressure Regulator >> Cabriolet

Brake Pressure Regulator: Cabriolet

  1. Raise and support vehicle. Attach Pressure Gauges (US 1016) to right front brake caliper and left rear brake cylinder. Bleed pressure gauge and hoses through valve on gauges.
  2. Pump brake pedal several times. Press on brake pedal until reading on front gauge shows pressure given for 1st reading in BRAKE PRESSURE TABLE (CABRIOLET) . Hold brake pressure to specification. Rear gauge reading should be within specification given for 1st reading in BRAKE PRESSURE TABLE (CABRIOLET).
  3. Increase pressure on brake pedal until reading on front gauge shows pressure given for 2nd reading in BRAKE PRESSURE TABLE (CABRIOLET). Hold brake pressure to specification. Rear gauge reading should be within specification given for 2nd reading in BRAKE PRESSURE TABLE (CABRIOLET). If pressures are within specification, brake pressure regulator is functioning properly. If pressures are not within specification, replace pressure regulator. Disconnect gauges and bleed brakes.
scientia non olet · About LEMON Manuals