LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 1984 >> Vanagon Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (1.6L 4-CYL Diesel/Turbo Diesel) >> Crankshaft Main & Connecting Rod Bearings >> Rear Main Bearing Oil Seal >> Installation

Rear Main Bearing Oil Seal: Installation

WARNING: This page is about a different car, the 1983 Volkswagen Vanagon, 1983 Volkswagen Rabbit, 1983 Volkswagen Quantum, 1983 Volkswagen Pickup, and 1983 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Install guide sleeve tool 2003/2A (or equivalent) over crankshaft flange. Start new seal into recess in carrier. Remove guide sleeve. Fit drive plate 2003/1 (or equivalent) and seat seal by tightening bolts.

scientia non olet · About LEMON Manuals