Removal (5-Cyl. Engine)
WARNING: This page is about a different car, the 1983 Volkswagen Vanagon, 1983 Volkswagen Rabbit, 1983 Volkswagen Quantum, 1983 Volkswagen Pickup, and 1983 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Remove vacuum pump pulley and belt. Remove belt cover for injection pump drive belt. Set crankshaft to TDC on compression stroke of cylinder No. 1. Check timing marks to verify crankshaft position. Marks are located on flywheel/clutch housing and on injection pump sprocket mounting plate.
- Lock injection pump sprocket in place with holding pin (2064). Hold injection pump drive sprocket with bar (3036). Remove drive sprocket retaining bolt, V-belt pulley, injection pump drive sprocket, and belt.