Axle Beam Pivot Bushing

WARNING: This page is about a different car, the 1984 Volkswagen Scirocco, 1984 Volkswagen Rabbit, 1984 Volkswagen Quantum, and 1984 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Removal

1) This procedure is for replacing bushing with axle beam installed in vehicle. Raise vehicle and support with saftey stands under vehicle body.

2) With no pressure on beam, remove nuts retaining axle beam to body and tap out pivot bolt.

3) Using Bushing Remover Tool (VW 516 and 30-555), press out bushing. Select new bushing and press bushing into place.

Installation

Loosely install mounting pad on axle beam. On Quantum models, use Bushing Installer Tool (VW 442 and 3046) install bushing (with power tool if possible). Install bushing to a depth of 2.42-2.44" (61.5-62.0 mm). Concave washer and bolt head must face toward outside of vehicle. Bolt head must recess into washer. Align mount as shown. See Fig 1. Tighten pivot bolt nut. Lower vehicle.

Fig 1: Correct Alignment of Axle Beam Mounting Pad