Vacuum Booster Check (Cis Fuel-Injected Models Only)
- An adjustable or non-adjustable vacuum booster is installed to increase vacuum to power brake unit. To check booster, warm engine until oil reaches 140°F.
- Install "T" connector between distributor vacuum unit and intake manifold. Gauge should read 7.4 in. Hg vacuum with engine idling. If not, check vacuum lines for leaks.
- If vacuum is as specified in step 2), check booster as follows: Remove and plug hose from right side of booster. Loosen lock nut (if equipped), and install vacuum gauge and hose.
- Gauge should read 11.8 in. Hg vacuum with engine idling. Adjust screw in or out to obtain correct reading (if equipped). Replace defective booster.