Axial Play Of Worm Spindle

Turn wheel to full left or right position. Loosen lock nut on worm spindle adjuster and turn spindle while tightening adjuster until no play is felt at coupling. Hold adjuster and torque lock nut. There should be no tight spots when spindle is turned.

1. 2)  Turn steering wheel 90° left or right. Loosen pitman arm shaft screw lock nut and turn screw out approximately one turn.
   NOTE: Adjusting screw is accessible through hole in luggage pan.

   Turn screw in until roller can be felt contacting worm. Hold screw and tighten lock nut.

2. 3)  With vehicle on ground, turn steering wheel 90° to each side and check play. If excessive play is present on one side, repeat adjustment to that side. Check toe-in and set, if necessary. Road test by cornering at 10-12 MPH. If steering wheel does not return to approximately 45° of center (unassisted), adjustment is too tight.