In Car Temperature Sensor And Solar Sensor Removal And Installation/Replacement

Mobile Repair Possible:  Van/Car

Overview: 

In car temperature sensor (1) 

Removal Procedure: 

1. Remove Instrument Panel Fuse Block Access Hole Cover. Refer to INSTRUMENT PANEL FUSE BLOCK ACCESS HOLE COVER REMOVAL AND INSTALLATION/REPLACEMENT
2. Reach through the opening (1) and unlock and disconnect electrical connector (2).
3. Reach through the opening (1) and carefully disengage the temperature sensor (2) with a suitable screwdriver at the points marked with black arrows.
4. Guide out the temperature sensor (2) in the direction of the arrow and remove it.

Installation Procedure: 

Installation note: Ensure correct latching (1). 

1. Installation is the reverse of removal procedure, noting the following.
2. Install Instrument Panel Fuse Block Access Hole Cover. Refer to INSTRUMENT PANEL FUSE BLOCK ACCESS HOLE COVER REMOVAL AND INSTALLATION/REPLACEMENT