Instrument Panel Ambient Light Driver Side Removal And Installation/Replacement

Mobile Repair Possible:  Van/Car

Overview: 

Fig 1: Instrument Panel Ambient Light Driver Side Components Location

Courtesy of VINFAST, LLC

Removal Procedure: 

1. Disconnect the 12V battery negative terminal. Refer to 12V BATTERY NEGATIVE CABLE DISCONNECTION/CONNECTION
2. Remove multimedia display rear trim panel. Refer to MULTIMEDIA DISPLAY REAR TRIM PANEL REMOVAL AND INSTALLATION/REPLACEMENT 

   Courtesy of VINFAST, LLC

3. Remove 3 screws (1).

   Torque: 3 Nm 

4. Move the ambient light in the direction of the arrows.
5. Unlock and disconnect the electrical connector (2).
6. Remove the instrument panel ambient light on the driver side.

Installation Procedure: 

1. Installation is the reverse of removal procedure, noting the following.
2. Install multimedia display rear trim panel. Refer to MULTIMEDIA DISPLAY REAR TRIM PANEL REMOVAL AND INSTALLATION/REPLACEMENT 
3. Reconnect the 12V battery negative terminal. Refer to 12V BATTERY NEGATIVE CABLE DISCONNECTION/CONNECTION