Instrument Panel Ambient Light Passenger Side Removal And Installation/Replacement

Mobile Repair Possible:  Van/Car

Overview: 

Fig 1: Instrument Panel Ambient Light Passenger Side Components Location

Courtesy of VINFAST, LLC

Removal Procedure: 

1. Disconnect the 12V battery negative terminal. Refer to 12V BATTERY NEGATIVE CABLE DISCONNECTION/CONNECTION
2. Remove instrument panel upper trim panel (Left Side). Refer to INSTRUMENT PANEL UPPER TRIM PANEL (LEFT SIDE) REMOVAL AND INSTALLATION/REPLACEMENT 
3. Remove instrument panel upper trim panel (Right Side). Refer to INSTRUMENT PANEL UPPER TRIM PANEL (RIGHT SIDE) REMOVAL AND INSTALLATION/REPLACEMENT 

   Courtesy of VINFAST, LLC

4. Remove 7 screws (1).

   Torque: 3 Nm 

5. Move the ambient light in the direction of the arrows.
6. Unlock and disconnect the electrical connector (2).
7. Remove the instrument panel ambient light on the passenger side.

Installation Procedure: 

1. Installation is the reverse of removal procedure, noting the following.
2. Install instrument panel upper trim panel (Right Side). Refer to INSTRUMENT PANEL UPPER TRIM PANEL (RIGHT SIDE) REMOVAL AND INSTALLATION/REPLACEMENT 
3. Install instrument panel upper trim panel (Left Side). Refer to INSTRUMENT PANEL UPPER TRIM PANEL (LEFT SIDE) REMOVAL AND INSTALLATION/REPLACEMENT 
4. Reconnect the 12V battery negative terminal. Refer to 12V BATTERY NEGATIVE CABLE DISCONNECTION/CONNECTION