A-Pillar Upper Trim Panel Removal And Installation/Replacement
Mobile Repair Possible: Van/Car
WARNING:
- Explosive materials
Failure to follow specified procedures may result in death or serious injury due to improper handling of airbags.
- Only appropriately trained persons may carry out work on pyrotechnic components or the Airbag Control Unit.
- Perform SRS disabling procedure prior to commencing work.
- When replacing components of the SRS system, never install used or non-genuine components.
- Pyrotechnic Components must be handled and scrapped appropriately.
Removal Procedure:
The procedure for the left-hand component is identical to that for the right-hand side.
- There is potential for inadvertent deployment of SRS systems during repairs if the system has not been properly disabled. Refer to SRS DISABLING AND ENABLINGNOTE: Ensure the 2-minute wait time has been observed before proceeding to next step.
- Disconnect the 12V battery negative terminal. Refer to 12V BATTERY NEGATIVE CABLE DISCONNECTION/CONNECTION
- Unclip and remove cover (1).
- Remove screw (1).
Torque: 2.3 Nm
Removal note: Do not use sharp-edged tools anywhere near the head airbag.
- Loosen 2 clips (2) under A-pillar upper trim panel (1) with suitable tools in arrow direction.
- Dismount and remove the A-pillar trim (1) from the dashboard (2).
Installation Procedure:
Installation note: Check clips (1) for damage and replace if needed.
- Installation is the reverse of removal procedure, noting the following.
All fasteners must be tightened to torque specification!
- Reconnect the 12V battery negative terminal. Refer to 12V BATTERY NEGATIVE CABLE DISCONNECTION/CONNECTION