Installation [03/2019 - ]: Procedure

1. Position the main muffler heat insulator.
2. Tighten nuts.

   Torque: 2.6 N.m (27 kgf/cm, 23 in.lbf) 

1. Position the rear No. 2 floor heat Insulator sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Tighten screws (1) and nuts (2).

   Nut 

   Torque: 2.6 N.m (27 kgf/cm, 23 in.lbf) 

   Screw 

   Torque: 2.0 N.m (20 kgf/cm, 18 in.lbf) 

1. Position the main muffler heat Insulator RH (3).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Tighten nuts (1).

   Torque: 3.0 N.m (31 kgf/cm, 27 in.lbf) 

3. Tighten down screws (2).

   Torque: 2.6 N.m (27 kgf/cm, 23 in.lbf) 

4. for RH Side:
   1. Clip in the holder.
   2. Attach the actuator with bracket assembly.

HINT: 

Use the same procedure as for the RH side.

Refer to INSTALLATION [03/2019 - ]