Installation [03/2020 - ]: Procedure

1. Install the No. 1 exhaust manifold heat Insulator.
2. Renew screws.
3. Tighten the screws.

   Torque: 19 N.m (194 kgf/cm, 14 ft.lbf) 

4. Install the No. 1 exhaust manifold heat Insulator (3).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

5. Renew screws (1).
6. Tighten the screws (1).

   Torque: 19 N.m (194 kgf/cm, 14 ft.lbf) 

7. Renew screws (2).
8. Tighten the screws (2).

   Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf) 

Refer to INSTALLATION [03/2019 - ]