Installation [06/2020 - ]: Procedure

1. Install the oil pump with motor assembly to the engine assembly with the 2 bolts.

   Torque: 46 N.m (469 kgf/cm, 34 ft.lbf) 

2. Connect the oil pump with motor assembly connector.
3. Install the wire harness clamp bracket to the oil pump with motor assembly with the bolt.

   Torque: 20 N.m (204 kgf/cm, 15 ft.lbf) 

1. Connect the No. 2 transmission oil cooler hose assembly to the oil pump with motor assembly and slide the 2 clips to secure it.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	0 to 3 mm (0 to 0.118 in.)
   *b	2 to 7 mm (0.0787 to 0.276 in.)
   *c	Paint Mark
   *d	Marking
   *e	Center of Paint Mark
   *f	45° (Claw of Clip Location)

   NOTE:

   • Make sure to slide the No. 2 transmission oil cooler hose assembly until it contacts the hose stopper of the oil pump with motor assembly.
   • Make sure to align the paint mark on each No. 2 transmission oil cooler hose assembly with each marking on the oil pump with motor assembly.
   • Make sure that the claws of the clip are within the location shown in the illustration.

Refer to INSTALLATION [06/2020 - ]

See step  6

Refer to PROCEDURE - Step 66

Refer to PROCEDURE - Step 67

Refer to PROCEDURE - Step 69

Refer to PROCEDURE - Step 68