LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2025 >> RAV4 Plug-In Hybrid XSE >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Testing and Diagnosis >> Hybrid Battery System (PHEV) - Diagnostic Codes (12 Of 12), Symptom Tests & Circuit Tests (1 Of 2) >> Hybrid Battery System >> Instructions for Connecting SST [06/2020 - ] >> Procedure

Instructions for Connecting SST [06/2020 - ]: Procedure

  1. CONNECT THE SST 
    • SST: 09893-42030 
    WARNING:

    Be sure to wear insulated gloves and protective goggles.

    NOTE:

    Make sure to observe the following points when using the SST.

    • Set it in a secure, flat place.
    • Set it in a dry place protected from dust and water.
    1. Connect the SST to the Ni1, Ni2, Ni3 HV supply battery assembly connectors and the HV supply battery assembly.
      NOTE:

      Make sure that the connector is connected securely.

      GTY999560Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 HV Supply Battery Assembly - -
      *a SST *b SST (Vehicle Side)
      *c SST (HV Supply Battery Assembly Side) - -

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    END 

scientia non olet · About LEMON Manuals