Installation [11/2018 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY
- Connect each connector.
*A for Type A *B for Type B - Insert the air conditioning amplifier assembly into the guide as shown in the illustration.
*A for Type A *B for Type B Insert in this Direction Rotate in this Direction - Rotate, and then attach to the guide as shown in the illustration.
- Move the air conditioning amplifier assembly in each direction shown in the illustration to check that the guide is securely engaged.
*A for Type A *B for Type B - Install the air conditioning amplifier assembly with the screw.
- Attach the clamp.
- Connect each connector.
- INSTALL ACCELERATOR PEDAL ASSEMBLY
- for A25A-FXS:
Refer to REMOVAL [11/2018 - ]
- for A25A-FKS:
Refer to INSTALLATION [11/2018 - ]
- for A25A-FXS:
- PERFORM REGISTRATION (w/ Stop and Start System)
Refer to REGISTRATION [11/2018 - 10/2019] , or refer to REGISTRATION [10/2019 - 12/2021] , or refer to REGISTRATION [12/2021 - 10/2022] , or refer to REGISTRATION [10/2022 - 10/2023] , or refer to REGISTRATION [10/2023 - ]