LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2025 >> RAV4 Plug-In Hybrid XSE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 64 (Meter / Gauge / Display - Service Information) >> Combination Meter >> Removal [11/2018 - 10/2022] >> Procedure

Removal [11/2018 - 10/2022]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH 

    Refer to PROCEDURE - Step 10 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 10 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 10 [10/2019 - 08/2020] , or refer to PROCEDURE - Step 11 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 11 [12/2021 - 10/2022]

  2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY 

    Refer to PROCEDURE - Step 11 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 11 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 11 [10/2019 - 08/2020] , or refer to PROCEDURE - Step 12 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 12 [12/2021 - 10/2022]

  3. REMOVE COMBINATION METER ASSEMBLY 
    1. Remove the 4 screws.
      GTY937132Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. GTY868413Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction

      Pull towards the rear of the vehicle to detach the clip and guide and remove the combination meter assembly.

    3. Detach the clamp and disconnect the 2 connectors.
      GTY855122Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A for 4.2 Inch Display
      *B for 7 Inch Display
scientia non olet · About LEMON Manuals