Installation [11/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL VACUUM SWITCHING VALVE (for Active Control Engine Mount System)
1. Install the vacuum switching valve (for active control engine mount system) to the front engine mounting insulator with the nut.
  Torque: 6.0 N.m (61 kgf/cm, 53 in.lbf)
2. Connect the 3 vacuum hoses to the vacuum switching valve (for active control engine mount system).
3. Attach the wire harness clamp and connect the vacuum switching valve (for active control engine mount system) connector.
4. Install the wire harness clamp bracket to the transmission case side cover with the bolt.
  Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
5. Attach the 2 wire harness clamps and install the engine wire with the bolt.
  Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf)
INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
See step 2 [11/2018 - 08/2020], or see step 2 [08/2020 - ]
INSTALL INLET AIR CLEANER ASSEMBLY
See step 3 [11/2018 - 08/2020], or see step 3 [08/2020 - ]
INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 76 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 76 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 76 [12/2021 - ]