Removal [10/2022 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

REMOVE GENERATOR ASSEMBLY
- for 100 A, 130 A Type:
  Refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]
- for 150 A Type:
  Refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]

REMOVE KNOCK CONTROL SENSOR

Disconnect the knock control sensor connector.

Remove the bolt and knock control sensor from the cylinder block sub-assembly.
NOTE:
If the knock control sensor has been struck or dropped, replace it.