LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2025 >> RAV4 Plug-In Hybrid XSE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 61 (Engine Control System (A25A-FKS) - Service Information) >> Knock Sensor >> Removal [08/2020 - 10/2022] >> Procedure

Removal [08/2020 - 10/2022]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE GENERATOR ASSEMBLY 
  2. REMOVE KNOCK CONTROL SENSOR 
    1. Disconnect the knock control sensor connector.
      GTY920683Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and knock control sensor from the cylinder block sub-assembly.
      NOTE:

      If the knock control sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals