Installation [11/2018 - 08/2020]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL ENGINE COOLANT TEMPERATURE SENSOR
HINT:

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
- w/ Canister Pump Module:
  Refer to INITIALIZATION [11/2018 - 10/2019] , or refer to INITIALIZATION [10/2019 - 08/2020]
- w/o Canister Pump Module:
  Refer to INITIALIZATION [11/2018 - 08/2020]
1. Apply a light coat of engine coolant to the O-ring of the engine coolant temperature sensor.
2. Install the engine coolant temperature sensor to the water outlet with a new clip.
  NOTE:
  - If the engine coolant temperature sensor has been struck or dropped, replace it.
  - If reusing the engine coolant temperature sensor, be sure to inspect the O-ring.
  - Make sure that the O-ring is not cracked or moved out of place when installing the engine coolant temperature sensor.
3. Connect the engine coolant temperature sensor connector.
INSTALL BATTERY
Refer to INSTALLATION [11/2018 - 10/2023]
INSTALL NO. 2 ENGINE COOLANT TEMPERATURE SENSOR (w/ Grille Shutter)
1. Apply a light coat of engine coolant to the O-ring of the No. 2 engine coolant temperature sensor.
2. Install the No. 2 engine coolant temperature sensor to the water outlet with a new clip.
  NOTE:
  - If the No. 2 engine coolant temperature sensor has been struck or dropped, replace it.
  - If reusing the No. 2 engine coolant temperature sensor, be sure to inspect the O-ring.
  - Make sure that the O-ring is not cracked or moved out of place when installing the No. 2 engine coolant temperature sensor.
3. Connect the No. 2 engine coolant temperature sensor connector.
INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE (w/ Grille Shutter)
See step 2
INSTALL INLET AIR CLEANER ASSEMBLY (w/ Grille Shutter)
See step 3
INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Grille Shutter)
Refer to PROCEDURE - Step 76
ADD ENGINE COOLANT
Refer to REPLACEMENT [11/2018 - ]
INSPECT FOR COOLANT LEAK
Refer to PROCEDURE - Step 1