Removal [10/2022 - 10/2023]: Procedure
WARNING: This page is about a different variant/trim than selected.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Refer to REMOVAL [10/2022 - 10/2023]
- REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 20
- REMOVE NO. 2 ENGINE COVER
Refer to PROCEDURE - Step 5
- REMOVE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY
- Disconnect the cam timing control motor with EDU assembly connector.
- Remove the 3 bolts and cam timing control motor with EDU assembly from the No. 2 timing chain cover assembly.NOTE:
If the cam timing control motor with EDU assembly has been struck or dropped, replace it.
- Remove the cam timing control motor O-ring from the No. 2 timing chain cover assembly.
- Disconnect the cam timing control motor with EDU assembly connector.