LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2025 >> RAV4 Plug-In Hybrid XSE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 61 (Engine Control System (A25A-FKS) - Service Information) >> ACTIVE CONTROL ENGINE MOUNT (for Rear Side) >> Removal [11/2018 - 08/2020] >> Procedure

Removal [11/2018 - 08/2020]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE FRONT FRAME ASSEMBLY 

    Refer to REMOVAL [11/2018 - 10/2019] , or refer to REMOVAL [10/2019 - 08/2020]

  2. REMOVE REAR ENGINE MOUNTING INSULATOR 
    1. Remove the bolt and rear engine mounting insulator from the rear engine mounting bracket.
      GTY920671Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and wire harness clamp bracket from the rear engine mounting insulator.
      GTY944380Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Detach the clamp and remove the vacuum hose from the rear engine mounting insulator.
      GTY920667Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals