LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2025 >> RAV4 Plug-In Hybrid XSE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 61 (Engine Control System (A25A-FKS) - Service Information) >> ACTIVE CONTROL ENGINE MOUNT (for Rear Side) >> Removal [08/2020 - 10/2022] >> Procedure

Removal [08/2020 - 10/2022]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE FRONT FRAME ASSEMBLY 

    Refer to REMOVAL [08/2020 - 12/2021] , or refer to REMOVAL [12/2021 - 10/2022]

  2. REMOVE REAR ENGINE MOUNTING INSULATOR 
    1. Remove the bolt and rear engine mounting insulator from the rear engine mounting bracket.
      GTY920671Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and wire harness clamp bracket from the rear engine mounting insulator.
      GTY944380Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Detach the clamp and remove the vacuum hose from the rear engine mounting insulator.
      GTY920667Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals