DTC C13A2: Engine Switch/Power Switch Malfunction [11/2018 - 02/2019]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK HARNESS AND CONNECTOR (IG POWER SOURCE CIRCUIT - PARKING BRAKE ECU ASSEMBLY)
- Turn the power switch off.
- Disconnect the parking brake ECU assembly connector.
*a Front view of wire harness connector
(to Parking Brake ECU Assembly) - Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Switch Condition Specified Condition M35-5 (IG) - Body ground Power switch on (IG) 11 to 14 V Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 2
- CHECK DTC
- Clear the DTCs.
Refer to DTC CHECK / CLEAR [11/2018 - 02/2019]
Chassis > Electric Parking Brake > Clear DTCs
- Turn the power switch off.
- Check for DTCs.
Refer to DTC CHECK / CLEAR [11/2018 - 02/2019]
Chassis > Electric Parking Brake > Trouble Codes
Result
Proceed to DTC is output DTC is not output
Result:
DTC is output
REPLACE PARKING BRAKE ECU ASSEMBLY. Refer to REMOVAL [11/2018 - 02/2019]
Result:
DTC is not output
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ]
- Clear the DTCs.