DTC C13AE: System information not received [02/2019 - 06/2020]: Procedure

1. Turn the ignition switch off.
2. Connect the Techstream to the DLC3.
3. Turn the ignition switch to ON and the Techstream on.
4. Check for DTC.

   Refer to DTC CHECK / CLEAR [02/2019 - 12/2021]

   Chassis > Electric Parking Brake > Trouble Codes 

   Result

   Result	Proceed to
   DTC C13AE and a CAN communication malfunction DTC are output at the same time	A
   DTC C13AE is output and the master warning is displayed on the multi-information display in the combination meter assembly.	B
   Only DTC C13AE is output	C
   No outputs	D

Result: 

A 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [02/2019 - ] 

Result: 

B 

GO TO HYBRID CONTROL SYSTEM 

for 2WD: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - 08/2020]

for AWD: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [02/2019 - ]

Result: 

C 

REPLACE PARKING BRAKE ECU ASSEMBLY. Refer to  REMOVAL [02/2019 - 10/2019]  , or refer to  REMOVAL [10/2019 - 08/2020] 

Result: 

D 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ]