Removal [10/2022 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE REAR WHEEL
Refer to REMOVAL [11/2018 - ]
- REMOVE LOWER NO. 2 CONTROL ARM COVER (w/ Cover)
- Remove the bolt.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the clip.
- Disengage the 2 claws and guide to remove the lower No. 2 control arm cover from the rear No. 2 suspension arm assembly.
- REMOVE REAR STABILIZER LINK ASSEMBLY
See step 14
- REMOVE REAR COIL SPRING
See step 4
- REMOVE REAR LOWER COIL SPRING INSULATOR
See step 6
- REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY
- Remove the nut, No. 2 camber adjust cam, rear suspension toe adjust cam sub-assembly and rear No. 2 suspension arm assembly.
NOTE:
Hold the rear suspension toe adjust cam sub-assembly while rotating the nut.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY
- Remove the 2 bolts, 2 nuts and rear No. 1 suspension arm assembly from the rear axle carrier sub-assembly and rear suspension member sub-assembly.
NOTE:
Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|