LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2025 >> RAV4 Plug-In Hybrid XSE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 315 (Seat Belt - Service Information (2 Of 2)) >> Rear Seat Inner Belt Assembly >> Removal [11/2018 - ] >> Procedure

Removal [11/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY 

    Refer to PROCEDURE - Step 1

  2. REMOVE REAR SEAT CUSHION LOCK HOOK 

    Refer to PROCEDURE - Step 2

  3. REMOVE REAR SEATBACK ASSEMBLY LH 

    Refer to PROCEDURE - Step 3

  4. REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY (FLOOR ANCHOR) 

    See step  3

  5. REMOVE REAR SEATBACK ASSEMBLY RH 

    Refer to PROCEDURE - Step 5

  6. REMOVE REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH 
    1. w/ Seat Belt Warning System:
      1. Disconnect the 2 connectors.
        GTY839603Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        Connector
        Bolt
    2. Loosen the bolt and remove the rear seat inner with center belt assembly LH.
  7. REMOVE REAR SEAT INNER BELT ASSEMBLY 
    1. w/ Seat Belt Warning System:
      1. Disconnect the connector.
        GTY852107Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        Connector
        Bolt
    2. Remove the bolt and rear seat inner belt assembly.
scientia non olet · About LEMON Manuals