Removal [08/2020 - 12/2021]: Procedure

WARNING: This page is about a different variant/trim than selected.

REMOVE AUTOMATIC TRANSAXLE ASSEMBLY
- for 2WD:
  Refer to REMOVAL [08/2020 - 12/2021]
- for AWD:
  Refer to REMOVAL [08/2020 - 12/2021]

REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat level surface.
NOTE:
- Using height adjustment attachments and plate lift attachments, keep the engine assembly level.
- To prevent the No. 2 oil pan sub-assembly from deforming, do not place any attachments under the No. 2 oil pan sub-assembly of the engine assembly.
- Using an engine sling device and engine lift, secure the engine assembly before servicing.

Using SST, hold the crankshaft pulley assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 8 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE NO. 1 CRANKSHAFT POSITION SENSOR PLATE

Remove the No. 1 crankshaft position sensor plate.

REMOVE REAR ENGINE OIL SEAL

Using a knife, cut off the lip of the rear engine oil seal.

*a	Protective Tape
*b	Cut Position