LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2025 >> RAV4 Plug-In Hybrid XSE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 181 (Seats - Service Information (5 Of 5)) >> Rear Seat Cushion Heater >> Removal [11/2018 - ] >> Procedure

Removal [11/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY 

    Refer to PROCEDURE - Step 1

  2. REMOVE REAR SEAT CUSHION LOCK HOOK 

    Refer to PROCEDURE - Step 2

  3. REMOVE BENCH TYPE REAR SEAT CUSHION COVER 

    Refer to PROCEDURE - Step 1

  4. REMOVE REAR SEAT CUSHION HEATER ASSEMBLY LH 
    1. Detach the clamp.
      GTY944755Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Tag Pin
      *a Clamp
    2. Remove the 20 tag pins and rear seat cushion heater assembly LH from the bench type rear seat cushion cover.
      NOTE:

      Be careful not to damage the bench type rear seat cushion cover and rear seat cushion heater assembly.

  5. REMOVE REAR SEAT CUSHION HEATER ASSEMBLY RH 

    HINT: 

    Use the same procedure described for the LH side.

scientia non olet · About LEMON Manuals