Removal [06/2020 - ]: Procedure

REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH

Remove the 2 screws and 3 clips.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

	Screw
	Clip

Put protective tape around the front fender moulding sub-assembly LH.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Protective Tape

Pull back the edge of the front fender liner LH and detach the claw by pushing the area indicated by the arrow in the illustration with a finger.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

	Place Hand Here
	Push in this Direction
	Remove in this Direction

NOTE:

Do not apply excessive force when pulling back the front fender liner LH.
To avoid damaging the claws, do not forcibly pull the front fender moulding sub-assembly LH.

Place your hand at the position shown in the illustration and detach the clip to remove the front fender moulding sub-assembly LH as shown in the illustration.

	Place Hand Here
	Remove in this Direction

When reusing the front fender moulding sub-assembly LH:

Remove the 7 clips.

NOTE:

Replace the clip with a new one.