LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2025 >> RAV4 Plug-In Hybrid XSE >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Door / Hatch - Service Information (2 Of 2) (PHEV) >> Power Back Door Closer Switch >> Inspection [06/2020 - ] >> Procedure

Inspection [06/2020 - ]: Procedure

  1. INSPECT NO. 1 POWER BACK DOOR CONTROL SWITCH 
    1. Check the operation of the No. 1 power back door control switch.
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Switch Condition Specified Condition
        1 (CLS) - 2 (E) No. 1 power back door control switch not pushed 10 kΩ or higher
        No. 1 power back door control switch pushed Below 1 Ω
        GTY374298Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (No. 1 Power Back Door Control Switch)

        If the result is not as specified, replace the No. 1 power back door control switch.

scientia non olet · About LEMON Manuals