Removal [06/2020 - 12/2021]: Procedure

Refer to REMOVAL [06/2020 - 12/2021]

WARNING:

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

• Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
• If the airbag deploys for any reason, it may cause a serious accident.

Refer to REMOVAL [06/2020 - 12/2021]

HINT: 

• Use the same procedure for the RH and LH sides.
• The procedure listed below is for the LH side.

1. Disconnect the connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Detach the claw and remove the rear corner ultrasonic sensor.
   NOTE:

   Before removing the sensor, make sure to mark the sensor and rear bumper assembly so that each sensor can be returned to its original position.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove in this Direction

HINT: 

• Use the same procedure for the RH and LH sides.
• The procedure listed below is for the LH side.

1. Disconnect the connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Detach the claw and remove the rear center ultrasonic sensor.
   NOTE:

   Before removing the sensor, make sure to mark the sensor and rear bumper assembly so that each sensor can be returned to its original position.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove in this Direction

HINT: 

• Perform the following procedure only when replacement of a rear corner ultrasonic sensor retainer is necessary.
• When removing the rear corner ultrasonic sensor retainer, if the double-sided tape is difficult to remove, heat the adhesive of the rear corner ultrasonic sensor retainer and rear bumper cover using a heat light.

1. Heat the rear bumper assembly and rear corner ultrasonic sensor retainer using a heat light.
   WARNING:

   • Do not touch the heat light and heated parts.
   • Touching the heat light may result in burns.
   • Touching heated parts for a long time may result in burns.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Heated Part
   *b	Heat Light

   Standard

   Item	Temperature
   Rear Bumper Assembly	40 to 60°C (104 to 140°F)
   Rear Corner Ultrasonic Sensor Retainer

2. Remove the rear corner ultrasonic sensor retainer.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT: 

• Perform the following procedure only when replacement of a rear center ultrasonic sensor retainer is necessary.
• When removing the rear center ultrasonic sensor retainer, if the double-sided tape is difficult to remove, heat the adhesive of the rear center ultrasonic sensor retainer and rear bumper cover using a heat light.
• Use the same procedure for the RH and LH sides.
• The procedure listed below is for the LH side.

1. Heat the rear bumper assembly and rear center ultrasonic sensor retainer using a heat light.
   WARNING:

   • Do not touch the heat light and heated parts.
   • Touching the heat light may result in burns.
   • Touching heated parts for a long time may result in burns.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Heated Part
   *b	Heat Light

   Standard

   Item	Temperature
   Rear Bumper Assembly	40 to 60°C (104 to 140°F)
   Rear Center Ultrasonic Sensor Retainer

2. Remove the rear center ultrasonic sensor retainer.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT: 

Only perform this procedure when removing and installing the ultrasonic sensor cushion set.

1. Remove the ultrasonic sensor cushion set as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove in this Direction

   -

   -