Installation [06/2020 - ]: Procedure

1. When installing the rear light assembly LH, secure the back window lower moulding to the surface of the back door glass with tape so that the back window lower moulding does not jam.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Back Window Lower Moulding
   	Tape

2. Attach the pin and clip and claw to install the rear light assembly LH.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Install in this Direction

3. Install the 3 nuts.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 3.2 N*m (33 kgf*cm, 28 in.*lbf) 

4. Connect the connector.
5. Return the back window lower moulding to its original position.

Refer to INSTALLATION [06/2020 - ]