Problem Symptoms Table [10/2022 - ]
NOTE:
- When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
- When replacing the combination meter assembly, always check that ECU security key is registered.
Refer to UPDATE ECU SECURITY KEY [06/2020 - ]
HINT:
- The following problem symptoms table is based on the assumption that each system related to the combination meter assembly is normal.
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
METER OR GAUGE
| Symptom | Suspected Area | Link |
|---|---|---|
| Entire combination meter assembly does not operate | Refer to "Entire Combination Meter does not Operate | Refer to Entire Combination Meter does not Operate [10/2022 - ] |
| Speedometer malfunction | Refer to "Speedometer Malfunction" | Refer to Speedometer Malfunction [06/2020 - ] |
| SOC gauge malfunction | Refer to "SOC Gauge Malfunction" | Refer to SOC Gauge Malfunction [06/2020 - ] |
| Fuel receiver gauge display malfunction | Refer to "Fuel Receiver Gauge Display Malfunction" | Refer to Fuel Receiver Gauge Display Malfunction [10/2022 - ] |
| Hybrid system indicator malfunction | Refer to "Hybrid System Indicator Malfunction" | Refer to Hybrid System Indicator Malfunction [10/2022 - ] |
WARNING OR INDICATOR
| Symptom | Suspected Area | Link |
|---|---|---|
| Other indicator lights malfunction | Combination meter assembly | Refer to REMOVAL [10/2022 - ] |
| Other warning lights malfunction | Combination meter assembly | Refer to REMOVAL [10/2022 - ] |
MULTI-INFORMATION DISPLAY
| Symptom | Suspected Area | Link |
|---|---|---|
| Multi-information display is not displayed | Combination meter assembly | Refer to REMOVAL [10/2022 - ] |
| "Engine Oil Level Low Add or Replace" display malfunction | Refer to "Engine Oil Level Sensor Circuit" | Refer to Engine Oil Level Sensor Circuit [10/2022 - ] |
| Combination meter assembly | Refer to REMOVAL [10/2022 - ] | |
| Other display malfunction | Combination meter assembly | Refer to REMOVAL [10/2022 - ] |
BUZZER
| Symptom | Suspected Area | Link |
|---|---|---|
| Other buzzers malfunction | Combination meter assembly | Refer to REMOVAL [10/2022 - ] |
OTHERS
| Symptom | Suspected Area | Link |
|---|---|---|
| Meter illumination is always dark | Refer to "Meter Illumination is Always Dark" | Refer to Meter Illumination is Always Dark [12/2021 - ] |
| Meter illumination does not dim at night | Refer to "Meter Illumination does not Dim at Night" | Refer to Meter Illumination does not Dim at Night [12/2021 - ] |
| Customization cannot be performed by setting customize settings on the setting tab of the multi-information display | Combination meter assembly | Refer to REMOVAL [10/2022 - ] |
| Other systems that use the speed signal do not operate normally | Refer to "Speed Signal Circuit" | Refer to Speed Signal Circuit [10/2022 - ] |
| Steering Pad Switch Circuit | Refer to "Steering Pad Switch Circuit" | Refer to Steering Pad Switch Circuit [10/2022 - ] |
| Odo/Trip Switch Malfunction (for 12.3 Inch Multi-information Display Type) | Refer to "Odo/Trip Switch Malfunction" | Refer to Odo/Trip Switch Malfunction [10/2022 - ] |