LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2025 >> RAV4 Plug-In Hybrid SE >> Repair and Diagnosis >> Suspension >> Front Suspension >> Suspension System (Front) - Service Information (PHEV) >> Front Stabilizer Bar >> Removal [06/2020 - 12/2021] >> Procedure

Removal [06/2020 - 12/2021]: Procedure

  1. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH 
    1. Remove the front shock absorber cap LH.
      GTY859646Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the nut and separate the front stabilizer link assembly from the front stabilizer bar.
      NOTE:

      Do not damage the boot of the ball joint.

      HINT: 

      If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.

  2. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH 

    HINT: 

    Perform the same procedure as for the LH side.

  3. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE 

    Refer to REMOVAL [06/2020 - 12/2021]

  4. REMOVE FRONT STABILIZER BAR PROTECTOR 
    1. Remove the clip.
      GTY859637Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the front stabilizer bar protector from the front stabilizer bar.
  5. REMOVE FRONT NO. 1 STABILIZER BRACKET LH 
    1. Remove the 2 bolts and front No. 1 stabilizer bracket LH from the front engine support member sub-assembly.
      GTY930914Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE FRONT NO. 1 STABILIZER BRACKET RH 

    HINT: 

    Perform the same procedure as for the LH side.

  7. REMOVE FRONT STABILIZER BAR 
    1. Remove the front stabilizer bar with 2 front stabilizer bar bushings from the front engine support member sub-assembly.
  8. REMOVE FRONT NO. 1 STABILIZER BAR BUSHING (for LH Side) 
    1. Remove the front No. 1 stabilizer bar bushing from the front stabilizer bar.
  9. REMOVE FRONT NO. 1 STABILIZER BAR BUSHING (for RH Side) 

    HINT: 

    Perform the same procedure as for the LH side.

scientia non olet · About LEMON Manuals