Installation [10/2022 - ]: Procedure

1. Install the auxiliary battery.
2. Install the battery clamp sub-assembly with the bolt and nut.

   Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf) 

3. Connect the battery hose to the auxiliary battery.
4. Connect the cable to the positive (+) auxiliary battery terminal and tighten the nut.

   Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf) 

5. Close the connector cover.

1. Connect the cable to the negative (-) auxiliary battery terminal and tighten the nut.

   Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf) 

1. Attach the 13 claws and install the battery hole cover.

1. Install the deck board assembly.

HINT: 

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [12/2021 - ]