Removal [10/2022 - ]: Procedure
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to REMOVAL [10/2022 - ]
- REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 23
- REMOVE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY
- Disconnect the cam timing control motor with EDU assembly connector.
- Remove the 3 bolts and cam timing control motor with EDU assembly from the No. 2 timing chain cover assembly.NOTE:
If the cam timing control motor with EDU assembly has been struck or dropped, replace it.
- Remove the cam timing control motor O-ring from the No. 2 timing chain cover assembly.
- Disconnect the cam timing control motor with EDU assembly connector.