Caution / Notice / Hint

NOTE:

Before replacing the main body ECU (multiplex network body ECU), refer to the Registration.
Refer to REGISTRATION [12/2021 - ]
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
When the combination meter assembly is replaced, update the ECU security key.
Refer to UPDATE ECU SECURITY KEY [06/2020 - ]

HINT:

The meter illumination dims when the taillights are turned on.
Setting the meter illumination level to maximum brightness cancels the above dimming of the meter illumination.
Setting the meter illumination level to minimum brightness turns off the meter illumination.
The automatic light control sensor sensitivity can be customized.
Refer to CUSTOMIZE PARAMETERS [12/2021 - 10/2022] , or refer to CUSTOMIZE PARAMETERS [10/2022 - ]