Removal [06/2020 - 12/2021]: Procedure

PRECAUTION

WARNING:

Be sure to read Precaution thoroughly before servicing.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to PRECAUTION [06/2020 - 10/2022]

NOTE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.

Refer to BEFORE DISCONNECTING BATTERY [06/2020 - 10/2022]

DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

WARNING:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.

Refer to REMOVAL [06/2020 - 12/2021]

REMOVE REAR DOOR INSIDE HANDLE BEZEL LH
Refer to PROCEDURE - Step 3
REMOVE DOOR ASSIST GRIP COVER LH
Refer to PROCEDURE - Step 4
REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
Refer to PROCEDURE - Step 5
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 8
REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH
Refer to PROCEDURE - Step 10
REMOVE REAR DOOR REAR BELT SEAL LH
Refer to PROCEDURE - Step 12
REMOVE REAR DOOR SERVICE HOLE COVER LH
Refer to PROCEDURE - Step 14
REMOVE REAR DOOR FRAME GARNISH LH
Refer to PROCEDURE - Step 15
REMOVE REAR DOOR GLASS RUN LH
Refer to PROCEDURE - Step 18
REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 17
REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 21
REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 22

REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

Using a T25 "TORX" socket wrench, remove the 3 "TORX" screws and power window regulator motor assembly LH from the rear door window regulator sub-assembly LH.