Removal [06/2020 - ]: Procedure

REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH
Refer to PROCEDURE - Step 3 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 3 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 3 [10/2022 - ]
REMOVE FRONT DOOR ASSIST GRIP COVER LH
Refer to PROCEDURE - Step 4 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 4 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 4 [10/2022 - ]
REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
Refer to PROCEDURE - Step 5 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 5 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 5 [10/2022 - ]
REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
Refer to PROCEDURE - Step 8 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 8 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 8 [10/2022 - ]
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 11 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 11 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 11 [10/2022 - ]

REMOVE OUTER MIRROR INSTALL HOLE COVER LH

Disconnect the connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the screw.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

Remove the 3 nuts.

Protective Tape

NOTE:

Hold the outer rear view mirror assembly LH with one hand so that it does not drop.

Using a thin-bladed screwdriver, detach the claw and guide to remove the outer rear view mirror assembly LH.
HINT:

Tape the thin-bladed screwdriver tip before use.