LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2025 >> RAV4 Plug-In Hybrid SE >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Door / Hatch - Service Information (2 Of 2) (PHEV) >> Power Back Door Closer Switch >> Removal [06/2020 - ] >> Procedure

Removal [06/2020 - ]: Procedure

  1. REMOVE BACK DOOR CENTER GARNISH 

    See step  1

  2. REMOVE BACK DOOR SIDE GARNISH LH 

    See step  2

  3. REMOVE BACK DOOR SIDE GARNISH RH 

    HINT: 

    Use the same procedure described for the LH side.

  4. REMOVE BACK DOOR HANDLE COVER 

    HINT: 

    Use the same procedure for the RH and LH sides.

    See step  4

  5. REMOVE BACK DOOR TRIM BOARD ASSEMBLY 

    See step  5

  6. REMOVE NO. 1 POWER BACK DOOR CONTROL SWITCH 
    1. Disconnect the connector and detach the clamp.
      GTY936200Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the claw and remove the No. 1 power back door control switch as shown in the illustration.
      GTY943187Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
scientia non olet · About LEMON Manuals