Inspection [06/2020 - ]: Procedure
- INSPECT FUEL LID LOCK WITH MOTOR ASSEMBLY
- Check the operation of the fuel lid lock with motor assembly.
*a Component without harness connected
(Fuel Lid Lock with Motor Assembly)- Apply auxiliary battery voltage to the fuel lid lock with motor assembly connector, and check that the fuel lid lock with motor assembly operates smoothly as follows.
OK
Auxiliary Battery Connection Specified Condition Auxiliary battery positive (+) → Terminal 1
Auxiliary battery negative (-) → Terminal 2Open Operation If the result is not as specified, replace the fuel lid lock with motor assembly.
- Measure the shaft stroke.
Standard
Area Condition Specified Condition A Lever pulled 15.45 to 16.65 mm (0.608 to 0.656 in.) If the result is not as specified, replace the fuel lid lock with motor assembly.
- Apply auxiliary battery voltage to the fuel lid lock with motor assembly connector, and check that the fuel lid lock with motor assembly operates smoothly as follows.
- Check the resistance of the limit switch.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 3 (B) - 2 (E) Fuel Lid Open Below 1 Ω 3 (B) - 2 (E) Fuel Lid Close 10 kΩ or higher If the result is not as specified, replace the fuel lid lock with motor assembly.
- Measure the resistance according to the value(s) in the table below.
- Check the operation of the fuel lid lock with motor assembly.