Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during back door disassembly/reassembly are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedures	Effect/Inoperative Function When Necessary Procedures are not Performed	Link
Multiplex network door ECU Power back door unit assembly set LH Power back door unit assembly set RH	Reset connection history	There are cases where the connection history display differs from the vehicle condition	Refer to DATA LIST / ACTIVE TEST [06/2020 - 10/2023] , or refer to DATA LIST / ACTIVE TEST [10/2023 - ]
	Reset back door close position	Power back door system	Refer to INITIALIZATION [06/2020 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]
Rear television camera assembly (Including removal and installation)	Parking assist monitor system initialization Television camera assembly optical axis (Back camera position setting)	Parking assist monitor system	Refer to CALIBRATION [06/2020 - 10/2022] , or refer to CALIBRATION [10/2022 - ]
	Rear television camera view adjustment	Panoramic view monitor system	Refer to CALIBRATION [06/2020 - 10/2022] , or refer to CALIBRATION [10/2022 - ]
Rear television camera assembly	Television camera view adjustment HINT: Replacement or removal and installation of 2 or more parts	Panoramic view monitor system	Refer to CALIBRATION [06/2020 - 10/2022] , or refer to CALIBRATION [10/2022 - ]