- REMOVE FRONT WHEEL
Refer to REMOVAL [06/2020 - ]
- REMOVE FRONT FENDER FRONT SPLASH SHIELD RH
- Remove the 4 screws.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Detach the claw and remove the front fender front splash shield RH.
- REMOVE NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 13 [06/2020 - 12/2021]
, or refer to PROCEDURE - Step 13 [12/2021 - 10/2022]
, or refer to PROCEDURE - Step 13 [10/2022 - ]
- REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH
HINT:
Use the same procedure described for the LH side.
Refer to PROCEDURE - Step 1
- REMOVE FRONT FENDER LINER RH
- Remove the 7 clips (A) and 2 screws.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
| *a |
Clip (A) |
*b |
Clip (B) |
 |
Clip |
 |
Screw |
- Remove the clip (B).
- Using a screwdriver with its tip wrapped with protective tape, detach the claw and remove the 5 grommets.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the front fender liner RH.
- DRAIN WINDSHIELD WASHER FLUID
- Disconnect the washer hose from the windshield washer motor and pump assembly, and drain the washer fluid.
HINT:
Use a container to collect the washer fluid.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
- Disconnect the washer hose from the windshield washer motor and pump assembly.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
 |
Remove in this Direction |
 |
Washer hose |
 |
Connector |
- Disconnect the connector.
- Remove the windshield washer motor and pump assembly as shown in the illustration.
- REMOVE FRONT BUMPER COVER
Refer to REMOVAL [06/2020 - 10/2022]
, or refer to REMOVAL [10/2022 - ]
- REMOVE WASHER INLET SUB-ASSEMBLY
- Remove the clip.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
 |
Place Hand Here |
 |
Remove in this Direction |
- Place your hands at the position shown in the illustration and remove the washer inlet sub-assembly in the direction indicated by the arrow.
- REMOVE WINDSHIELD WASHER JAR ASSEMBLY
- Detach the clamp and disconnect the washer hose.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Detach the clamp.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Disconnect the connector.
- Remove the 3 bolts. Then detach the guide and remove the windshield washer jar assembly.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE LEVEL WARNING SWITCH ASSEMBLY
See step 3