Installation [06/2020 - 10/2022]: Procedure

1. Install the No. 2 multi-media module bracket with the 4 screws.

   Torque: 3.0 N.m (31 kgf/cm, 27 in.lbf) 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the No. 1 multi-media module bracket with the 3 screws.

   Torque: 3.0 N.m (31 kgf/cm, 27 in.lbf) 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Connect the 2 connectors to install the telephone ECU wire (to transceiver).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Attach the clamp to install the No. 2 navigation wire.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Connect the connector.

1. Attach the clamp to install the No. 2 antenna cord sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Connect the 4 connectors.

1. Connect each connector.
2. Place your hand at the position shown in the illustration, and then while bending the instrument panel safety pad assembly, attach the guide to temporarily install the navigation ECU with bracket.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Place Hand Here
   	Install in this Direction

3. Connect the 3 connectors.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Bolt
   	Connector

4. Attach the clamp.
5. Install the 2 bolts.

   Torque: 12 N.m (122 kgf/cm, 9 ft.lbf) 

Refer to PROCEDURE - Step 27

Refer to PROCEDURE - Step 1

Refer to INSTALLATION [06/2020 - 12/2021] , or refer to INSTALLATION [12/2021 - ]